Datagrid problem in standalone

[Trevor DeVore]

On Jun 8, 2009, at 3:14 PM, Beat Cornaz wrote:

> I followed the instructions, but it did not work. After that I  
> experimented a bit over the weekend and found the 'problem'.
> The substack "Data Grid Templates 12343etc" got created all right,  
> so no need for the  "Data Grid Templates Dud" substack. The reason  
> why the datagrids did not work in the standalone is that somehow the  
> revdatagridLib did not load all right. After opening the separate  
> stack "revdatagridLib" that you've sent me, I was told that the  
> stack already exists in memory and I choose the 'Purge' option.

After quitting Rev you should backup and replace the  
"revdatagridlibrary.rev" stack in the ./Toolset/ folder of your Rev  
installation with the stack I sent you. The IDE will use this stack  
when it launches and when it builds the standalone.

> Now in the "stacks" in the standalone settings (card 2) I saw the  
> revdatagridLib as a separate stack and after completing the  
> standalone  it works all right now. I suspect it might have  
> something to do, that I started the project in a pre 3.x version and  
> just recently - because of the datagrids :-) , I downloaded the 3,5  
> trial version, where I am completing the project.
> I absolutely don't like the new editor (that was the reason I stayed  
> on pre 3.x), but the datagrids and multidimensional arrays are great.
>
> Now the datagrid works in the standalone. But I do not understand  
> why it would not work in the beginning. Why do I have to explicitely  
> load and include the revDatagridLib as it is already 'inside' of rev  
> 3.5?

Try doing the replace I mentioned above and see if you run into any  
problems going forward.

Regards,

-- 
Trevor DeVore
Blue Mango Learning Systems
www.bluemangolearning.com    -    www.screensteps.com