Standalone to .dmg

[Robert Presender]

Thank you Andre for your response.  The DMG volume permissions are OK.  
I can't recall if I had the same kind of problem when I was using Mac 
10.2.6.  As I recall, I believed it worked when I used the trial copy 
of Rev2.1 (which has expired) so I can't test it now.  It could be the 
10.2.8 version which I recently upgraded to.  Will wait for the trial 
code for Rev 2.1.1 (which is taking a long time to be received) and see 
if that works,

Regards ... Bob

On Sunday, October 19, 2003, at 06:50 AM, Andre Alves Garzia wrote:

> On Sunday, October 19, 2003, at 11:38  AM, Robert Presender wrote:
>
>> Hi,
>>
>> Using Rev  2.1RC1 and Mac 10.2.8, a standalone build works fine and
>> user entries are saved as they should be.  Also works fine when the
>> standalone is compressed using Stuffit (.sit).
>>
>> When using .dmg (standalone dragged to disk copy),  the mounted
>> standalone works fine except that user entries are not saved.
>
>
> Bob,
>
> The DMG volume might be flaged as read-only, that way you'll not be
> able to right nothing inside it, just check in the upper corner for a
> crossed pencil (it's look like a crossed pencil for me), this marks
> read-only volumes.
>
> cheers
>
>
>>
>> I am awaiting a trial code for Rev 2.1.1 to see if .dmg works in this
>> version.
>>
>>  In the meantime, does any one know if .dmg works in 2.1 or 2.1.1?
>>
>> Will appreciate comments or suggestions.
>>
>> Regards ... Bob
>>
>> _______________________________________________
>> use-revolution mailing list
>> use-revolution at lists.runrev.com
>> http://lists.runrev.com/mailman/listinfo/use-revolution
>>
>>
> Andre Alves Garzia  2003  BRAZIL
> http://www.soapdog.org
>
>
> ------------------------------
>