Problem with Script Editor in LC 9.6.2 (rc3)

Bob Sneidar bobsneidar at iotecdigital.com
Wed Mar 24 18:40:41 EDT 2021


Same LC version but not Big Sur. I was able to scroll properly while selecting text. 

Bob S


> On Mar 24, 2021, at 2:05 PM, HENRY LOWE via use-livecode <use-livecode at lists.runrev.com> wrote:
> 
> Since updating to LC 9.6.2 (rc3) on a 2019 iMac running Mac OS Big Sur 11.2.3 I have been experiencing the following intermittent issue:
> 
> If I select text in the LC Script Editor and then drag down to select additional text (e.g. I want to select an entire handler), the editor starts to autoscroll and does not stop until it reaches the end of the script text. Nothing I do stops the scrolling and text selection. I am locked out of LC, which is unresponsive. Activity Monitor shows that LC is using 100% of the CPU while in this ‘autoscrolling’ state. Once the scroll reaches the end of the text in the editor pane, I get control of LC again. 
> 
> This is only happening with a very large script 5900 lines of text (238K). I am in the progress of breaking this script up into a series of smaller scripts.
> 
> I suspect that this issue is related to the large amount of text in the script but have not seen this before with this script until I updated to LC 9.6.2 (rc3).
> 
> Can anyone confirm this issue?
> 
> Also, is there an upper limit to the size of a LC script?
> 
> Thanks,
> 
> Henry
> _______________________________________________
> use-livecode mailing list
> use-livecode at lists.runrev.com
> Please visit this url to subscribe, unsubscribe and manage your subscription preferences:
> http://lists.runrev.com/mailman/listinfo/use-livecode



More information about the use-livecode mailing list