LC902 and LC901 message box error was LC902 and LC901 Hang with Answer (was Crash
J. Landman Gay
jacque at hyperactivesw.com
Thu Feb 21 13:04:11 EST 2019
If the message box is misdirecting commands, that may fit with some
problems I've seen too. I couldn't set behavior on a button, menu key
shortcuts fail all the time, and calling a handler from the message box
periodically reports the handler can't be found even though the message box
title field says the target stack is the one I'm looking at. Also, like
you, Cmd-S periodically fails to do anything and contextual menus don't
appear when right-clicking.
I open the message box at startup and never close it.
--
Jacqueline Landman Gay | jacque at hyperactivesw.com
HyperActive Software | http://www.hyperactivesw.com
On February 20, 2019 10:32:52 PM Ralph DiMola via use-livecode
<use-livecode at lists.runrev.com> wrote:
> A new twist. A ctrl S will work normally until I open the message box. The
> inspector will also open OK. Open up the message box and close it. Now a
> ctrl S will cause the message box to open(last command is displayed but not
> executed) then the stack will be saved normally. Also the inspector will no
> longer open. Close the message box and do a Ctrl S and again the message box
> opens up. Strange indeed.
More information about the use-livecode
mailing list