Cursor changes to a hand in the ide

[Jim Byrnes]

On 02/25/2016 07:25 PM, Richard Gaskin wrote:
> Jim Byrnes wrote:
>
>  > On 02/25/2016 06:35 PM, Richard Gaskin wrote:
>  >> Try this in the Message Box (replacing "YourStack" with your stack's
>  >> name of course):
>  >>
>  >>    put the mode of stack "YourStack" && the style of stack "YourStack"
>  >>
>  >
>  > This results in: 2 toplevel
>
> Hunch confirmed:  if you look up mode in the Dictionary you'll see the
> mode is an integer that refers to the current state of the stack.
>
> Stack modes can be made persistent with the style property, but you can
> also temporarily change the mode of a stack without changing the
> persistent style property by using the style name as a command, e.g.:
>
>    palette "some stack"
>
> ...will open it as a palette, but if its style is toplevel then using:
>
>    open stack "some stack"
>
> ...will open it in its style, toplevel.
>
> There is one other way to affect mode, specific to mode 2:  that one's
> cantModify, which can be affected by setting the stack's cantModify
> property.
>
> So if you run this in the Message Box you should be good to go:
>
>    set the cantmodify of stack "YourStack" to false
>
> Then save it, or you'll be back in this spot again next time you open it.
>

That worked, thank you very much.  I must say this is a friendly, 
helpful group.

Regards,  Jim