Differences between standalone results and IDE results
revlists at canelasoftware.com
Mon Mar 1 19:24:45 CST 2004
This is true most of the time. I close and reopen the AB. You really
do not need it when you run my sample script. You can tell what card
you are on. What is interesting is that Rev stops running code past
the "clone this card" line. It just stops. It does not crash or hang.
I just stops. MC on the other hand does not stop.
Here is the link again if you or anyone else is interested. I think
this is an underlying problem that should be affecting more people.
On Mar 1, 2004, at 6:36 AM, Thomas McGrath III wrote:
> After a clone the Application Browser does not always update right
> away. Close the AB and then reopen it while still in the IDE and it
> should now say 2.
> On Mar 1, 2004, at 1:11 AM, Mark Talluto wrote:
>> Hi Everyone,
>> This is going to be sorta vague right now. I am running into a
>> situation where I am getting a particular result from my app running
>> in the IDE vs a Standalone.
>> I am cloning a card.
>> In the IDE the visible card after the clone is card 1 of 2.
>> In the Standalone the visible card after the clone is card 2 of 2
>> (which is the way it should be I believe).
>> A lot is going on so a simple recipe stack has been impossible to
>> create as of yet. This might (probably is) be related. When I have
>> "Script Debug Mode" on, the stack does not execute completely. It is
>> hanging on the "clone this card" line.
>> I tested this on MC 2.5 and it ran in both the IDE and Standalone
>> with the same results.
>> Has anyone here had something like this happen to them? I will
>> bugzilla this once I can create a recipe without having to send in my
>> whole app.
>> Best regards,
>> Mark Talluto
>> use-revolution mailing list
>> use-revolution at lists.runrev.com
> Thomas J. McGrath III
> 1000 Killarney Dr.
> Pittsburgh, PA 15234
> use-revolution mailing list
> use-revolution at lists.runrev.com
More information about the use-livecode