Differences between standalone results and IDE results

[Thomas McGrath III]

After a clone the Application Browser does not always update right 
away. Close the AB and then reopen it while still in the IDE and it 
should now say 2.

HTH

Tom

On Mar 1, 2004, at 1:11 AM, Mark Talluto wrote:

> Hi Everyone,
>
> This is going to be sorta vague right now.  I am running into a 
> situation where I am getting a particular result from my app running 
> in the IDE vs a Standalone.
>
> I am cloning a card.
> In the IDE the visible card after the clone is card 1 of 2.
> In the Standalone the visible card after the clone is card 2 of 2 
> (which is the way it should be I believe).
>
> A lot is going on so a simple recipe stack has been impossible to 
> create as of yet.  This might (probably is) be related.  When I have 
> "Script Debug Mode" on, the stack does not execute completely.  It is 
> hanging on the "clone this card" line.
> I tested this on MC 2.5 and it ran in both the IDE and Standalone with 
> the same results.
>
> Has anyone here had something like this happen to them?  I will 
> bugzilla this once I can create a recipe without having to send in my 
> whole app.
>
> -- 
> Best regards,
> Mark Talluto
> http://www.canelasoftware.com
> _______________________________________________
> use-revolution mailing list
> use-revolution at lists.runrev.com
> http://lists.runrev.com/mailman/listinfo/use-revolution
>
>

Thomas J. McGrath III
SCS
1000 Killarney Dr.
Pittsburgh, PA 15234
412-885-8541