No object selected

[Bob Sneidar]

I wonder what happens if you copy a card to a new stack, save it then use the inspector? 

Bob S


> On Sep 20, 2019, at 13:16 , J. Landman Gay via use-livecode <use-livecode at lists.runrev.com> wrote:
> 
> On 9/19/19 4:01 PM, Mark Wieder via use-livecode wrote:
>> On 9/19/19 10:05 AM, Marty Knapp via use-livecode wrote:
>>> Anybody had this happen - I have an older LC stack that works fine and in LC 9.5 I can edit the script of all the controls, but when I try to open the property inspector it will show the name of the object at the top of the inspector window but is says "no object selected" The only exception is for the stack itself, it will open for that.
>> Yep. Have seen that one. Pre-9.5 works ok.
> 
> Same problem with the message box too. The label shows the stack name but the handlers can't be found. This goes back a ways but is more pronounced in 9.5.
> 
> -- 
> Jacqueline Landman Gay         |     jacque at hyperactivesw.com
> HyperActive Software           |     http://www.hyperactivesw.com
> 
> _______________________________________________
> use-livecode mailing list
> use-livecode at lists.runrev.com
> Please visit this url to subscribe, unsubscribe and manage your subscription preferences:
> http://lists.runrev.com/mailman/listinfo/use-livecode