Navigator 6.4 alpha 1 is out

Geoff Canyon gcanyon at gmail.com
Mon Oct 1 20:28:13 EDT 2018


I went ahead and fixed this. In my working copy of Navigator the property
is displayed as being "name" but displays the short name. Editing it sets
the name. I made some fundamental changes to the way Navigator works over
the past few days so I'm going to use it for a bit before releasing it.

gc

On Mon, Oct 1, 2018 at 4:23 PM Geoff Canyon <gcanyon at gmail.com> wrote:

> Yeah (sigh) it's down to the fact that you can *get* the short name of
> something, but you can't *set* the short name of something. So I need to
> special case that one property :-(
>
> It's been an annoyance forever, but I always put off fixing it because it
> offends me.
>
> But since you brought it up I'll go ahead and special case it. Any
> preference on whether I should call the property "name" but special case to
> display/edit the short name, or instead to call the property "short name"
> but set the name? I lean toward continuing to call the property "name" and
> special case the display, but I'm open to arguments.
>
> gc
>
> On Mon, Oct 1, 2018 at 3:54 PM Mark Wieder via use-livecode <
> use-livecode at lists.runrev.com> wrote:
>
>> On 09/24/2018 08:19 PM, Geoff Canyon via use-livecode wrote:
>> > As usual, you can get Navigator here
>> > <https://www.dropbox.com/s/kz3zqi4botzglgq/navigator.zip?dl=1>. Or
>> grab it
>> > from GitHub <https://github.com/gcanyon/navigator>.
>>
>> Due to the huge number of behavior scripts (rev_b_*, rev_c_*, rev_f_*,
>> rev_g_*, rev_i_*, rev_s_*...) I can't figure out how to fix this for
>> you, so it's in your court:
>>
>> Getting the card list for a stack shows
>> card "name_of_card_1"
>> card "name_of_card_2"
>> etc.
>>
>> Editing the properties to change the card name, the value is also
>> card "name_of_card_1" rather than the short name. If I edit the name and
>> save it, then refresh the card list (problem #1 is that the list should
>> refresh automatically after the change is made), the card is named
>> card "card "name_of_card_1"", adding another "card".
>> So problem #2 is that the card list display shows a "card" identifier
>> and this is erroneously copied into the the value field for the card
>> name, compounded by the fact that when the new card name is saved extra
>> quotes are added to the card name whether or not they're needed.
>>
>> And I verified that it actually does change the card name thusly, so
>> it's not just a display issue.
>>
>> --
>>   Mark Wieder
>>   ahsoftware at gmail.com
>>
>> _______________________________________________
>> use-livecode mailing list
>> use-livecode at lists.runrev.com
>> Please visit this url to subscribe, unsubscribe and manage your
>> subscription preferences:
>> http://lists.runrev.com/mailman/listinfo/use-livecode
>>
>



More information about the use-livecode mailing list