Printing a portion of a card

[Sarah]

Thanks for the idea Richard, but I already tried setting the 
printMargins.
Perhaps I should try setting the top margin to a negative number :-)

Sarah

On Monday, November 25, 2002, at 11:06  am, Richard Gaskin wrote:

> Sarah wrote:
>
>> I have a problem with printing the bottom portion of a card. It prints
>> the correct bit of the card but I can't get it to start at the top 
>> left
>> of the paper, it always prints down the page as if leaving room for 
>> the
>> non-printed section of the card.
>>
>> Here is my setup:
>>
>> The card is 723 pixels wide x 560 high.
>> The page setup is for A4 paper in landscape mode.
>> This gives a printPaperSize of 841,595 (with the default printMargins)
>>
>> I want to print the card from 4,157 to 719,554.
>> Here is the command I am using:
>> print this card from 4,157 to 719,554 into 72,72,697,451
>>
>> Surely this should make the printout start 1 inch from the top and 1
>> inch from the left of the paper. It looks like it starts 1 inch from
>> the left but about 3 inches from the top.
>>
>> If anyone has any suggestions I would be most grateful. I use Mac OS X
>> 10.2.2, Rev 1.1.1
>
> You may need to adjust the printmargins global property.
>
> -- 
>  Richard Gaskin
>  Fourth World Media Corporation
>  Developer of WebMerge 2.1: Publish any database on any site
>  ___________________________________________________________
>  Ambassador at FourthWorld.com       http://www.FourthWorld.com
>  Tel: 323-225-3717                       AIM: FourthWorldInc
>
> _______________________________________________
> use-revolution mailing list
> use-revolution at lists.runrev.com
> http://lists.runrev.com/mailman/listinfo/use-revolution
>