[ANN] bnGuides has been updated

Bob Sneidar bobsneidar at iotecdigital.com
Tue Oct 12 11:15:52 EDT 2021


IOC! If an object is selected, THAT is when the behavior is applied, and when deselected THAT is when the behavior is removed. Works as advertised then. :-) To test I closed your stack after deselecting the button then checked the behavior again, which was cleared. 

Bob S


> On Oct 11, 2021, at 16:58 , Niggemann, Bernd via use-livecode <use-livecode at lists.runrev.com> wrote:
> 
>> Bob Sneidar via use-livecode Mon, 11 Oct 2021 16:42:20 -0700
>> 
>> I see. I think I did not maky myself clear. With the object inspector open and 
>> the behavior tab selected, before dragging the object with the pointer tool, 
>> there is no behavior registered. Upon dragging the object, the tool works as 
>> advertised, and that is the coolest thing since sliced bread, however the 
>> behavior for bnGuides is registered in the inspector, and remains registered 
>> even after I stop dragging the object. 
> 
> Just in case I did not make it clear: the behavior is removed when the selection of the dragged is, well, deselected. Independend of dragging.
> 
> To see that in the Properties inspector you would have to lock the Properties Inspector for that object and after deselecting the object you would have to change the tab in the Properties Inspector and go back to the "Behavior" tab to see that the behavior is gone.
> 
> Kind regards
> Bernd





More information about the use-livecode mailing list