Finally found one.

Pierre Sahores sc at sahores-conseil.com
Tue Oct 2 15:40:48 CDT 2012


Jacque,

Try inside opencard :

if MyStartUpVar is not a number then  
send opencard to this cd in 0 milliseconds
put "1" into MyStartUpVar
end if

or :

something with message without waiting

Best,

Pierre

Le 2 oct. 2012 à 22:06, J. Landman Gay a écrit :

> On 10/2/12 12:49 PM, Mark Wieder wrote:
>> Craig-
>> 
>>> I thought of that, but believed that the "send in time", where I even
>> increased the time value to, say, 100 ticks, would be more than enough to allow
>> the engine to "rest".
>> 
>> It's not a matter of giving the engine time to "rest". See below.
> 
> I added "wait 0 with messages" to Craig's card handler and it didn't work. :( I've been tinkering with it and I can't find anything so far that makes it work.
> 
> I did think that sending a message in time allows a brief idle state where the engine would pick up any pending user actions. I've used it with a 0 millisecond send in order to force events to go through. In this case I can't find anything that allows the Stop button to work.
> 
> -- 
> Jacqueline Landman Gay         |     jacque at hyperactivesw.com
> HyperActive Software           |     http://www.hyperactivesw.com
> 
> _______________________________________________
> use-livecode mailing list
> use-livecode at lists.runrev.com
> Please visit this url to subscribe, unsubscribe and manage your subscription preferences:
> http://lists.runrev.com/mailman/listinfo/use-livecode

--
Pierre Sahores
mobile : 06 03 95 77 70
www.sahores-conseil.com




More information about the use-livecode mailing list