script works only during debugging

[Peter Haworth]

It's on the same card.
Pete
lcSQL Software <http://www.lcsql.com>



On Thu, May 10, 2012 at 2:36 PM, Bob Sneidar <bobs at twft.com> wrote:

> Hmmm... I seem to recall a similar issue. If you are not on the card that
> contains the "abc" button, then LC will not know about it yet. Try changing
> your script to refer to the button as button "abc" of card "<thecardname>"
> and see what happens.
>
> Bob
>
>
> On May 10, 2012, at 12:37 PM, Mark Wieder wrote:
>
> > Peter Haworth <pete at ...> writes:
> >
> >>
> >> Well, there is one thing worse that that - somethig that works in the
> IDE
> >> but not in a standalone.
> >
> > PowerDebug is the only way to debug running standalones interactively.
> >
> >> I have a situationlike that right now where a simple "send mouseUp to
> >> button "abc" where the sender is on the same card as button "abc".
>  Works
> >> fine in the IDE but fails in a standalone, with the error message "Hint"
> >> being the button "abc".
> >
> > Could there be an error in the mouseUp handler in the button? What's the
> error
> > code number? The button is named "abc" without spaces or quotes? Can you
> tell if
> > it's the send command or the mouseUp handler that's at fault?
> >
> > --
> > Mark Wieder
> >
> >
> >
> > _______________________________________________
> > use-livecode mailing list
> > use-livecode at lists.runrev.com
> > Please visit this url to subscribe, unsubscribe and manage your
> subscription preferences:
> > http://lists.runrev.com/mailman/listinfo/use-livecode
>
>
> _______________________________________________
> use-livecode mailing list
> use-livecode at lists.runrev.com
> Please visit this url to subscribe, unsubscribe and manage your
> subscription preferences:
> http://lists.runrev.com/mailman/listinfo/use-livecode
>