how to for making a commercial library for runrev (barcode analysis)

runrev at animabit.de runrev at animabit.de
Wed Jul 2 06:13:30 EDT 2008


Hello colleagues,

I have made a program in runrev which gets the jpg data of 5 scanservers with scanned labels and analyses the 2 to 4 barcodes 39. After a testing phase with permanent improvement it now works 8 hours a day connecting to 3-5 scanservers stable. The project was part of quality assurance in an industrial environment.
In another project (an older one) a runrev prog looks permanently to a directory where scanned images are stored by a scanner, and moves and analyses and comments on these images.
The barcode analysis is completely programmed in transcript (500-700 msec per scan with 4 to 30 captures of subareas of the image - black/white conversions with different filters and barcode analysis). The quality of the jpgs is 150 dpi (normally 300 dpi is the starting point of doing barcode scans ...) where one small barcode line (one modul) is about one pixel - hard task, but there are millions of those jpgs a month and storage over years should not explode ... 
A test for 128 barcode (possible only with higher resolution starting about 200 dpi) had been successful, but was not finally needed for this project and must be improved for final application.

Now I think about making a commercial barcode analysis library for runrev.

Does there exist any standards how to make commercial libraries in runrev?
How to spread a password protected library stack in the community?


Regards,
Mit freundlichen Grüßen
Franz Böhmisch

boehmisch at animabit.de
http://www.animabit.de
GF Animabit Multimedia Software GmbH
Am Sonnenhang 22
D-94136 Thyrnau
Tel +49 (0)8501-8538
Fax +49 (0)8501-8537



More information about the use-livecode mailing list