expand the boundaries of a group

[xbury.cs at clearstream.com]

Hi Bob,

Just make the rect of the group larger before your resize. I tend to 
locklocation each group
to make sure it is always correctly refreshed. Then you can resize/move 
the buttons without
loosing sight of them...

cheers
Xavier

On 09.05.2005 14:56:59 use-revolution-bounces wrote:
>Hi All.
>
>I have been experimenting with some simple grouping. If I have a stack of 
one
>size and put 3 controls on it and group them, then the group is only as 
big as
>the area of the controls. Now I have a problem, since my controls are
>resizeable by the user, therefore, when the resize to bigger than the 
original
>group area, the resized controls are not totally visible. Is there a way 
to
>make the group area as big as the card?
>
>Cheers
>Bob
>
>
>_______________________________________________
>use-revolution mailing list
>use-revolution at lists.runrev.com
>http://lists.runrev.com/mailman/listinfo/use-revolution


-----------------------------------------
Visit us at http://www.clearstream.com
IMPORTANT MESSAGE    Internet communications are not secure and therefore
Clearstream International does not accept legal responsibility for the
contents of this message.    The information contained in this e-mail is
confidential and may be legally privileged. It is intended solely for the
addressee. If you are not the intended recipient, any disclosure, copying,
distribution or any action taken or omitted to be taken in reliance on it,
is prohibited and may be unlawful. Any views expressed in this e-mail are
those of the individual sender, except where the sender specifically states
them to be the views of Clearstream International or of any of its
affiliates or subsidiaries.    END OF DISCLAIMER