CNC software by Rev

[Thomas McGrath III]

Hello guys,

Is this possible on the Mac? I would love to 'find' a cnc and work on 
some ideas I have. Can you guys let me know what you are up to with 
this.

Thanks

Tom

On Jul 8, 2004, at 5:41 PM, Mark MacKenzie wrote:

> Great!!  I suspected as much.  I expect I will have the same problems. 
>  However, I need to make this work and will put a fair bit of effort 
> into it.  As a "jackleg" tool and die machinist in an other life I 
> might manage to triumph over the vagaries of inanimate objects such as 
> CNC drills taking on a life of their own.  Or maybe this will be the 
> beginning of a bad science fiction novel gone real!
>
> Can't wait to see your work.  Thank you in advance.
>
> Mark MacKenzie
>
> Mark Wieder wrote:
>
>> Mark-
>>
>> I started on a CNC controller some time last year. I'll dig out what
>> I've got and send it to you. The hard part isn't figuring out the CNC
>> protocol (the "G" commands and such) but getting the controller part
>> right so you don't snap off drill bits or have things flying across
>> the room.
>>
>>
>
> _______________________________________________
> use-revolution mailing list
> use-revolution at lists.runrev.com
> http://lists.runrev.com/mailman/listinfo/use-revolution
>
>

Thomas J. McGrath III
SCS
1000 Killarney Dr.
Pittsburgh, PA 15234
412-885-8541