Cloning oddity

[Thomas McGrath III]

I had a situation where I cloned 100 stacks into substacks of the main 
stack. On a certain number the Rev IDE would freeze up. I had to force 
quit.
My situation was that each clone was a number letter combo ie "13i" and 
"13ii" etc.
It so happened that the clone it stopped on was one without any letters 
in it. ie. "17" no "i" etc.
Also, the stack became corrupted/sick and I could not delete the 
trouble clone. I had to go back to a saved version and try again.

I added a letter to it and was able to clone that one and get past that 
number. All others cloned OK.
I assumed that was what it was anyway but it may have been a certain 
number of clones that it crashed on. Since I just proceeded after that 
clone and not from the beginning I don't know if a certain number of 
clones may have been at fault.

Tom

On Jan 24, 2004, at 3:22 PM, David Squance wrote:

> I have a script which stops on one step which involves cloning a card.
> There's no error message.  The same script works fine to a certain 
> point,
> cloning other cards, but when it reaches a certain one, won't go any
> further.  The standalone (OS X, same as development) works fine.  I 
> tried
> running it in the IDE with suppressing (or is it suspending) the
> development environment, but I had to force quit Rev.  Any suggestions?
>
>
> _______________________________________________
> use-revolution mailing list
> use-revolution at lists.runrev.com
> http://lists.runrev.com/mailman/listinfo/use-revolution
>
>

Thomas J. McGrath III
SCS
1000 Killarney Dr.
Pittsburgh, PA 15234
412-885-8541