I don't understand the SWITCH command?

[xbury.cs at clearstream.com]

Francois,

But the problem is surely with the usage of the "selectedline" where
you should use the hilitedline... For ListBehavior fields, the 
selectedline
doesn't work... 

hope that helps

On 13/01/2004 13:59:54 use-revolution-bounces wrote:
>Hello everybody!
>I have a problem with the "Switch" command.
>Here is my little Code:
>
>on mouseup
>put word 2 of the selectedline of me into nbcalc
>
>switch nbcalc
>
>case 1
>put 0 into fld "nbcalc"
>
>case 2
>
>put 2 into fld "nbcalc"
>end switch
>
>end mouseup
>
>It's always the case 2 that's done, even if the nbcalc is 1!
>What's wrong please?
>
>
>Amicalement
>François
>
>
>--------------
>François Cuneo
>Site Web dédié au Macintosh http://www.cuk.ch
>E-mail: francois.cuneo at cuk.ch
>
>_______________________________________________
>use-revolution mailing list
>use-revolution at lists.runrev.com
>http://lists.runrev.com/mailman/listinfo/use-revolution


Visit us at http://www.clearstream.com
                                                          
IMPORTANT MESSAGE

Internet communications are not secure and therefore Clearstream International does not accept legal responsibility for the contents of this message.

The information contained in this e-mail is confidential and may be legally privileged. It is intended solely for the addressee. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. Any views expressed in this e-mail are those of the individual sender, except where the sender specifically states them to be the views of Clearstream International or of any of its affiliates or subsidiaries.

END OF DISCLAIMER