Grabbing HTTP Header

[Richard Gaskin]

Dan Shafer wrote:

> Thanks, Monte.
> 
> I got your post on the Rev list. The engine is in the right place and
> referenced correctly. A simple CGI that doesn't involve parsing the incoming
> headers but just puts up a message works just fine.
> 
> I have set the permissions on the script to 755, so that is right as well.
> 
> I just can't make the very script that you present below run on my system and
> I'm completely befuddled as to why. One of the problems is I can't figure out
> where on OSX there might be a log I can check to see more precisely what's
> going wrong here.

Ignore my last email.

Rather than testing read, writing, and configuration, have you considered
dropping the number of unknowns by just writing a constant?:

#!mc
on startup
  put "this is a test"
end startup


-- 
 Richard Gaskin 
 Fourth World Media Corporation
 Developer of WebMerge 2.2: Publish any database on any site
 ___________________________________________________________
 Ambassador at FourthWorld.com       http://www.FourthWorld.com
 Tel: 323-225-3717                       AIM: FourthWorldInc